Green on White Two-Tone Acrylic
Green on White Two-Tone Acrylic
Low stock
Green on White Two-Tone
DISCLAIMER: Due to the manufacturing process, there was some colour bleed on the front side of the sheet. Severity of colour bleed may vary. Minor marks may be visible on the back side part of the sheet as well. All sales are final.
Opacity: | Opaque |
Side 1: | Glossy |
Side 2: | Glossy |
Colour: | Green outer layer that engraves white |
Material: | Cast Acrylic |
Thickness: | 3 mm (1/8") for all sizes |
Masking: | Plastic on both sides |
Please allow a +/- 0.5" variation for length & width and +/- 10% variation in density.
Engrave settings tested on a 90W laser: Speed 300/35% Power - Air assist off
Need a custom size? Please contact us for more information.
Glowforge Settings Recommendation
Glowforge Settings Recommendation
Suggested settings for 3 mm (1/8") thick acrylic:
To CUT: Power - FULL; Speed - 160
To ENGRAVE: Power - FULL; Speed - 1000
We recommend testing a small patch as each machine may perform differently. Settings should be adjusted accordingly if the patch test is not successful.
Please note that some acrylic settings (i.e. for glitters and marbles) might need to be adjusted by increasing power and slowing speed as they may be slightly thicker.
Care Instructions
Care Instructions
To avoid warping, store acrylic at no more than a 10 degree angle standing or lay flat with smaller pieces on top.