lyndecreekacrylic
Glitter Red on White Two-Tone Acrylic
Glitter Red on White Two-Tone Acrylic
In stock
Couldn't load pickup availability
Glitter Red on White Two-Tone
| Opacity: | Opaque |
| Side 1: | Glossy, glitter |
| Side 2: | Glossy |
| Colour: | Red micro glitter outer layer that engraves white |
| Material: | Cast Acrylic |
| Thickness: | 3 mm (1/8") for all sizes |
| Masking: | Plastic on both sides |
Please allow a +/- 0.5" variation for length & width and +/- 10% variation in density.
Engrave settings tested on a 90W laser: Speed 375/35% Power - Air assist off
DISCLAIMER: Due to the manufacturing process, there may be some colour bleed on the backside of the sheet and this is not considered a defect. While some minor marks may be visible on the anterior part of the sheet, they should not be very noticeable. Please contact us if you observe the sheet has obvious marks on it.
Need a custom size? Please contact us for more information.
Glowforge Settings Recommendation
Glowforge Settings Recommendation
Suggested settings for 3 mm (1/8") thick acrylic:
To CUT: Power - FULL; Speed - 160
To ENGRAVE: Power - FULL; Speed - 1000
We recommend testing a small patch as each machine may perform differently. Settings should be adjusted accordingly if the patch test is not successful.
Please note that some acrylic settings (i.e. for glitters and marbles) might need to be adjusted by increasing power and slowing speed as they may be slightly thicker.
Care Instructions
Care Instructions
To avoid warping, store acrylic at no more than a 10 degree angle standing or lay flat with smaller pieces on top.
Share
